|
| Hole tapering bit I made. Drill a hole from 1 inch up and with this tool put a taper in it with 10 turns or so depending on the hardness and grain of the wood. Cutting blade is a piece of band saw blade incerted into the kerf teeth down. Back edge then sharpened to about a 10 degree angle. |  |
| « | < | 20 | 21 | 22 | 23 | | |
|
|
| 23 Images | Technoprimitive.org | Weaver Combat Ranch | Generated by JAlbum 6.5 & Chameleon skin | Help |
| This page, all images, and content Copyright © 2006-2007 By David E. Patty All Rights Reserved |
|