Cutting the front top piece. Using aviation snips. Very tiring on the hand and arm muscles.

Front top covering. Flap in middle is easier explained in a later picture.

Doing it’s turkey impression. Ended up cutting the outer wide pieces off and only using the top 3 and reshaping 2 of them.

Top front flap explained. Keeps water from being able to get in at that point.

Still got the red strip to put in.

Got the red to put in and some screws to add, corner molding to put on and tis almost ready to roll. New (to this camper) tires with tubes are now mounted on the rims and on the camper. Took me a bit to do it by hand but I managed.

And the flaps are now explained. Still got to get caulk and take it all up, seal and put back down but it all fits.

Front of trailer with molding in place. Twas dark when we got finished so this is the best picture I could get.

And the back with molding in place. The molding was off the popup. Bit of cutting and some brute force with a hammer and it went right on.

Left is the same, just no light over there. Will try for better pix tomorrow in the light.