Comments (0)

By Dave, November 2, 2011 11:44 pm

Got a bit more done on the front wall but nowhere near as much as I wanted to get done. Gonna go out after supper and get more caulk.

Now to set front side supports, then I’ll know where the pieces on the back wall will go. 😉

Uprights in place at front of camper. Next set the front support for the bed. That gives the width at that height to figure side wall angle.

Floor is done, or at least enough for use. Now, at long last, to start on the walls. Hope they doesn’t take as long or spill as much blood.

But am getting closer to starting on the walls. I guess that’s a good thing.

3 more pieces of plywood to put down and the floor will be done. And I have to go get more caulk. Already used either 9 or 10 tubes.

More blood spilled from foot injuries. 3rd one today. No power tools involved. Think it just may be time to put on socks and real shoes. 🙁

Going back at it to try to finish the plywood layer of the floor so I can start on the walls.

Previous post “7” was supposed to be “&”. 🙁 That kind of morning…

Guess that’s what I get for no socks and sandals while working on it. Trimmed the toenail 7 the wood and screwed it down (the wood that is).

Cleaned the floor again and while fitting a piece of plywood, it stuck coming out, I pulled too hard and folded a big toenail in half.

Got the front bottom board installed after about an hour of cutting and trimming some strange angles to fit around the tongue and braces.

Time to go stir supper again.

On the camper anyway. Gonna put one of the knockdown tables up, set beads out, and see about getting a bracelet or necklace made in a bit.

Moved the tools and debris from the floor and then swept it off. Shut the power off and called it a night. Too tired to do any more tonight.