Comments (0)

By Dave, May 23, 2012 11:59 pm

Finally got some energy. Ground a few of the lucite pegs down, then cleared off the cutting table off, and moved the sheet of foam onto it.

Problem is I’m too tired to finish up the project I’d started on. Taking a break, will go back to it later in the day if I find the energy.

Finally drilled a small center hole and used an end mill bit to cut the center hole. Rock is now dead true!

Found a piece of lucite to cut a new spacer from. Turned down the outside and went to drill the center hole and the bit wouldn’t cut true.

Found the grind rock was out of round after reseating it on the hand grinder. Had forgotten that I’d used an old socket as a center spacer.

Today seems to be one of those days. Started out wanting to clean up the ends of plastic rods that I had cut to use for jewelry display.