Comments (0)

By Dave, May 24, 2012 12:08 am

Tin over that and on to the inside…

Then will grind and cut the surface smooth and cover the entire top with billboard plastic. Caulked seam right down the top center board.

Found more in the piles by the equipment trailer. Tied the top down and am about ready to start foaming the roof bits into one solid mass.

As well as some of the other roads/paths in the woods up here around the compound. Added the new batch to the old and still needed more.

Went into the spillway & got some that was left there from the air soft days. Cut on the way back too & cleared around the storage trailer.

Needed more so I cranked the tractor and cut the roads up to the dam and to the bamboo thicket.

Used as much of the strapping as I had here and got a little over half way to tying the outside strips to foam them into place.

Cut the strips out of the sheet and fitted them into the openings on the roof of the camper.