Comments (0)

By Dave, June 14, 2012 5:28 am

Looks like you reduce the size of the jets so will either peen them down with a hammer or solder over them and re-drill to proper size.

Got to find the orifice diameter for propane & see if I have to drill the ones in these out. Guess worse case, I can check one on the grill.

Took 2 3 eye gas burner units apart as far as they would go without impact. Got all of the threaded bits soaking in penetrating oil.

May drop a few trees too. Need to get them down and peeled so they’ll have time to dry a bit before they get used in the framework.

Got more fuel today so am going to try to harvest another load of bamboo tomorrow morning.

After looking at the blueberry bush below the barn tonight I’m gonna have to pick another big batch tomorrow morning.

Got the window cut out in the front panel and one of the pieces cut for the door end. One more to go. Getting closer.

@GreatDismal It converts standard ball foot air chuck into a blow gun. See http://t.co/6E2W007R