Comments (0)

By Dave, January 17, 2010 11:55 pm

Would really like to get the tub/shower enclosure back in place too but suspect that will have to wait till tomorrow.

At this rate doesn’t look like it’s all gonna get done tonight. May get far enough along to get the washer and drier back in place. Hope so.

First tier is ready to get plastic and then blueboard. Tis about time, too. Taking a break prior to getting the plastic out and starting.

Oh, well, it’s only time. And another cross piece will make the shell stronger. He says to himself trying to convince self not to be pissed.

Shoulda measured it rather than assuming. Has been so long since I bought it I totally forgot it was 9′ outside sheathing.

Got the first piece of blueboard in and am gonna have to put another cross piece in. Forgot the blueboard was 9 feet rather than 8. 🙁

when the battery went dead. Got about 3 of those pieces to go and then get to start fitting the blueboard. Getting closer anyway…

All the lower tier (up to 8′) bits along the curved wall are now in place. Was screwing in some end wall (south) belting/nailers whatever

Battery recharge break. Meant to put it on while I ate lunch and forgot it, so now when I’m raring to go it dies and has to be recharged.

Lunch break. 3 more uprights to cut and install and then I can start fitting the first of the blueboard panels. Highwire (ladder) work next.

Coffee breaks over, time to return to an inverted position.

Bit by bit, I think it’s starting to come together. Keep waiting for the other shoe/boulder to drop and require it to all be redone…

Will put it together as soon as the bottom row of foam is put in. Hopefully just after lunch. Which will be delayed as breakfast was late.

Have decided to build a platform to put the washer and drier on rather than continue using the cement blocks. Got all the parts cut.

Bottom piece of wall upright to screw foam to installed. Next 2 uprights cut and ready to go in. Coffee break required and being taken now.