Camper progress Oct 21 – 22, 2007
Been one of those days. Will fill in on that part later. For now here are pix of the bits I have gotten donein the past couple of days.
Continue reading 'Camper progress Oct 21 – 22, 2007'»
Been one of those days. Will fill in on that part later. For now here are pix of the bits I have gotten donein the past couple of days.
Continue reading 'Camper progress Oct 21 – 22, 2007'»
Still going. Starting to build the inside cabinets, toilet and storage areas. Have now stared at it long enough and finally decided how to built most of it so things should start moving a bit faster.
Continue reading 'Camper progress Oct 20, 2007'»
Been working and not posting. Got all the top pieces in. Finally! Never again will I do one quite this way. But I have learned a LOT doing it. And a lot not to do again. Getting to the point of building the interior now. Should go faster than the ceiling went. Still got lots of molding to do but that can be done most any time. Slowly, slowly getting this elephant eaten… 😉
Continue reading 'Last couple of days work on the camper'»
Should have taken pix of this thing before tearing it down but hindsight is 20/20. The tag receipt I found the other day shows it to be a 1974 “Harm” model 7ft (???). The heater paper work was printed 5/66 and the water tank has a date stamp of Oct 66. No serial # on the frame that I can find and if there were tags anywhere else I can’t find them either. So, can anyone help me get any closer?
Continue reading 'Trying to figure out what make/model this camper was'»
Heater flue wind deflector closups.
Getting closer. Got almost all the ceiling panels bent and in place. One more on top and the front wall to go. Hope to get that done tomorrow weather permitting.
Got the windows in (and yes, Steve, they ARE the only type of Windows that I do) as well as the door. Still got a lot of the inside to finish but getting a LOT closer every day.
Outside of the camper is almost done. Still got a lot to do inside, as well as all the wiring both 12 and 120 volt, but getting a lot closer.
Trying a new version of the posting program for iPhoto. This one is susposed to put it all in one post if that’s selected. Will see…
Last 13 posts were supposed to be one post. Tried to use iPhoto to auto post to wordpress but it didn’t work like I thought it would. Was gonna redo the posts but think I will leave them as is. Going to work up a album of all the pix of the camper rebuild and post it at some point so all the pix will be there anyway.
Looking like it will take a couple of tubes of caulk to finish the roof and exposed seams. Those will get covered with aluminum edging, salvaged from the popup and the camper the windows came from.
Closer than we were this morning. Hope to get the outside sealed up tomorrow. Then will move on to the inside and see if I can decide what to do in there…
More as I get it done.
Back is skinned and ready for the door molding and corners caulked and trim molding installed. Cat is looking contented (and tired)…
Continue reading 'Back Skinned'»
Right side skinned except for one piece. Front roof piece will have to come off tomorrow and be cut. Then one more piece will have to be cut for the front curve. Red strip will continue there also.
Continue reading 'Right Side Close'»
Left side with almost all the skin on. Top pieces lacked 2 inches meeting the sides and needed a bit of color anyway so I lapped a piece of red over the sides and under the top. Will cut the last piece and get it on tomorrow.
Continue reading 'Left Side Close'»
Inside front after all the skin plywood is done.
Continue reading 'Inside Front Done'»
Entry needing another 2 pieces of plywood and it will be ready for skinning.
Continue reading 'Entry'»
Right side ready for skinning. The additional pices at the upper left was to shed water cause the tarps weren’t quite big enough to fully cover the area.
Continue reading 'Right Side Ready'»
Left side with screw tips ground down and ready for the skin.
Continue reading 'Ready For Skinning'»
Front top showing more pieces that need to be put in. Had 3 more pieces on top that had to be finished.
Continue reading 'Front Top'»
Right side as I uncovered it this morning. Skin is on.
Continue reading 'Right Side'»
Panorama Theme by
Themocracy